rubber gasket Rubber gasket A sheetlike rubber product that acts as a seal between two stationary surfaces of a metal flange or other connection. It can be molded or vulcanized. Can be widely used in all kinds of mechanical equipment, play the role of padding, sealing, buffering and so on.

Formally, commonly used rubber gaskets include: rubber flat gaskets, rubber O-rings, plastic flat gaskets, polytetrafluoroethylene gaskets, asbestos rubber gaskets, metal flat gaskets, metal shaped gaskets, metal clad gaskets, waveform gaskets, wound gaskets, etc.

What is the difference between rubber gaskets and gaskets?
Rubber gaskets are molded, there are cutting, molding is the use of hydraulic forming machine and mold pressing, cutting is the use of gasket cutting machine cut out, compared to the mold saving, but relatively single, a mold can only do a gasket, gasket cutting machine can be cut in the 1500mm range of any size, but the utilization rate of the plate is not very high.

gasket (gasket) is a mechanical seal between two objects, usually used to prevent pressure, corrosion, and natural expansion and contraction of pipes between two objects. Since the machined surface cannot be perfect, irregularities can be filled with gaskets. Gaskets are usually made of sheet-like materials such as pad paper, rubber, silicone rubber, metal, cork, felt, neoprene, nitrile butadiene rubber, fiberglass or plastic polymers (such as teflon).

A washer is a hole (usually in the middle) in a thin (usually round) sheet. It is usually a threaded fastener for distributing the load, a part, usually a flat metal ring, between the connector and the nut. Other uses are as spacers, springs (Belleville gaskets, wave gaskets), wear pads, pre-display devices, locking devices. Rubber washers are also used in faucets (valves) to cut off the flow of liquids or gases. Rubber or silicon gaskets can also be used to reduce fan vibration. Usually the outer diameter of the gasket is about twice the inner diameter